INSTRUCTIONS LED3-408C-A, CB-A, CS-A
ipcw.com
02-07 DG RAM PU L.E.D. MEGA 3RD BRAKE LIGHT
Your new IPCW L.E.D. MEGA 3rd Brake Light is a quality-made product that will work beautifully on your vehicle.  Please refer to the
pictures below for installation.
1.
2.
3.
4.
Stock 3rd brake light. Use a (Phillips) screwdriver to remove stock screws (2).  Keep the screws for Step 9. Gently pull out the stock light. Disconnect the stock light from factory harness.
5.
6.
7.
8.
Remove (IPCW) LED MEGA 3RD BRAKE LIGHT from box.. On the (IPCW) MEGA Light,  remove 6 screws that go around the lens of the light.  Keep the screws for Step 11. (IPCW) MEGA 3rd brake light is a 2-piece light. Lens & Lightbar is 1 piece. Base is 1 piece.  First, place the Base over the vehicle's 3rd brake light opening.
9.
10.
11.
12.
Use the screws kept in Step 2 to screw the Mega 3rd brake light Base on vehicle. Connect the (IPCW) MEGA Light to factory harness and push the wire harness into the opening. Then, screw the MEGA light Lens & Lightbar to the Base using same (6) screws kept in Step 6. Make sure all screws are secured and the LED MEGA 3rd brake light is functioning properly.
Text Box: NOTE: INSTALLING L.E.D. LAMPS After you have installed the new lamps, you should: 1. Test the lights to make sure all L.E.D. bulbs light up. 2. Check to make sure the Cruise Control operates (if the vehicle is equipped). Need More Technical Support? If the vehicle experiences any of the following conditions after you have done these procedures, please feel free to contact us at (323)838-5588. You will be able to speak with someone. Or if you prefer, you can e-mail us at technical@inprocarwear.com. We will be more than happy to provide you with the technical support you need. 1. The warning lights on the dashboard lights up (example: ABS, Cruise Control, or maintenance lights). 2. The turn signals flash much rapidly than normal.
Done! Thank you for your 
purchase. We hope you enjoy
your new IPCW LED MEGA
3RD BRAKE LIGHT.
(Shown in Crystal Clear #LED3-408C-A)