READ ME FIRST!		Installation Instructions
	LED3-501AAC, AAS, AC, AS		LED 3RD BRAKE LIGHT
	00-05 EXCURSION
	(If your vehicle is F150/F250LD, see intructions for F150/F250LD.)
	Your new Crystal Eyes L.E.D. 3rd Brake Light is a quality-made product that will work beautifully on your vehicle.
	Please refer to the pictures below for installation.
1.		2.		3.
	Open rear Liftgate & pull off the upper interior panel.		Unplug stock connector and the harness securing clip.		Unscrew & remove stock third brake light.  Keep screws for Step 8.
4.		5.		6.
	There is a rubber plug in the light opening.  Pull it out along with all the stock wiring harness.		Take the new IPCW 3rd brake light and put its wiring harness through the hole.		Pull wire harness through underneath the Liftgate & connect the new light to stock connector.
7.		8.		9.
	Re-install the upper interior panel on the inside of the Liftgate.		Screw on the new light with screws kept in Step 1.		Done!
10.
			Thank you for your purchase.  We hope you enjoy your new IPCW 3rd Brake Light.