READ ME FIRST! Installation Instructions
LED3-501CC, CS 97-03 FORD PU / F150 / F250 LD
Your new Crystal Eyes L.E.D. 3rd Brake Light is a quality-made product that will work beautifully on you vehicle.
Please refer to the pictures below for installation.
1. 2. 3.
Unscrew the stock third brake light. There is a rubber plug in the stock light opening, unplug it. Pull the plug out a few inches to expose the connector hole.
4. 5. 6.
Cut wires away from vehicle and outside. Then, slide the rubber plug off the wire harness and discard. Take out the new Crystal Eyes L.E.D. 3rd brake light and peel off black plastic covering a few inches.  Cut black plastic covering off. Put red clips provided on all three of the colored wires by clamping over each of the wires with pliers.
7. 8. 9.
Then attach your new light to stock wires by clamping the other side of the clip, black wire to black wire. Clamp orange wire to green wire, and white wire to black/blue striped wire. Gently tuck all wires and clips and wire into the opening.
10. 11. 12.
Close the hole with plug provided with the new light.
Screw on the new light. Done!  Thank you for your purchase.  We hope you enjoy your new Crystal Eyes 3rd Brake Light.