INSTRUCTIONS LEDC-2038C, S
ipcw.com
07-09 FJ CRUISER FRONT LED TURN SIGNALS 
Your new IPCW L.E.D. Turn Signal are quality-made products that will work beautifully on your vehicle.  Please refer to the
pictures below for installation.
1.
2.
3.
4.
Pry open the 1 plastic cover on each side below the turn signal.  Take off the 1 plastic cover and keep it. Remove the 8mm nut below stock turn signal.  Keep the nut. Remove the 8mm nut on the inside, behind the turn signal. Keep the nut.
5.
6.
7.
8.
Use a screwdriver to pull up on plastic cap and remove plastic clip. Remove plastic cap & clip.  Gently pull on turn signal to unclip from fender of vehicle & remove stock light. Twist & unlock socket from stock turn signal & remove light bulb. 
9.
10.
11.
12.
Take (IPCW) L.E.D. Turn Signal out of box. Gently pull out the connector from IPCW light & plug it into socket.   Be sure to twist & lock socket to L.E.D. Turn Signal to seal the light closed. Repeat Steps 1-7 backwards  to reinstall lights. 
13.
Text Box: NOTE: INSTALLING L.E.D. LAMPS After you have installed the new lamps, you should: 1. Test the lights to make sure all L.E.D. bulbs light up. 2. Check to make sure the Cruise Control operates (if the vehicle is equipped). Need More Technical Support? If the vehicle experiences any of the following conditions after you have done these procedures, please feel free to contact us at (323)838-5588. You will be able to speak with someone. Or if you prefer, you can e-mail us at technical@inprocarwear.com. We will be more than happy to provide you with the technical support you need. 1. The warning lights on the dashboard lights up (example: ABS, Cruise Control, or maintenance lights). 2. The turn signals flash much rapidly than normal.
ipcw.com
                             
Done!  Thank you for your purchase.  We hope you enjoy your new IPCW LED Turn Signals.