INSTRUCTIONS | LEDT-2038C,CB,CR,CS |
|
|||||||||||||||||||
07-UP FJ CRUISER | LED TAILLIGHTS | ||||||||||||||||||||
Your new IPCW L.E.D. TAILLIGHT are quality-made products that will work beautifully on your vehicle. Please refer to the | |||||||||||||||||||||
pictures below for installation. | |||||||||||||||||||||
1. | ![]() |
2. | ![]() |
3. | ![]() |
4. |
|
||||||||||||||
Open liftgate to remove plastic covering in the cargo space. | Remove side storage cover above the plastic covering in Step 1. | Inside of side storage cover, there is another cover. Remove it as well. | Unscrew the 8mm bolt on each side of the hooks. | ||||||||||||||||||
5. | ![]() |
6. | ![]() |
7. | ![]() |
8. |
|
||||||||||||||
Remove hooks on each side. | Remove plastic cap & clip next to the side storage cover. | After removing all bolts & screws unclip side panel from the body. | Remove 10mm nut located on upper part of cavity. | ||||||||||||||||||
9. | ![]() |
10. | ![]() |
11. | ![]() |
12. |
|
||||||||||||||
Remove 10mm nut located on lower part of cavity. | Pull away inner plastic panel to get to the third 10mm nut. | Gently pull stock taillight out. | Remove turn & brake light bulbs. | ||||||||||||||||||
13. | ![]() |
14. | ![]() |
15. | ![]() |
16. |
|
||||||||||||||
Remove (IPCW) L.E.D. Taillight from box. | Connect 3-wire plug to 3-wire stock socket. Twist & lock to seal the light. Make sure it is sealed and the wires match (Black to Black wire). | Connect 2-wire plug to 2-wire stock socket. Twist & lock to seal the light. | Twist & lock reverse light socket with stock bulb into light and seal it. Reverse Steps 1-11 to install light on vehicle. Repeat the procedures for the other side of taillight. | ||||||||||||||||||
17. | ![]() |
![]() |
|||||||||||||||||||
Done! Thank you for your purchase. We hope you enjoy your new IPCW LED TAILLIGHTS. | |||||||||||||||||||||
(Show with LEDT-2038CR Ruby Red) | |||||||||||||||||||||