INSTRUCTIONS			LEDT-313C, CB, CR, CS
	07-09 CHEVY TAHOE			LED UPPER QUARTER PANEL LIGHT
	07-09 YUKON / SUBURBAN / ESCALADE
	Your new IPCW LED Upper Quarter Panel Lights are quality-made products that will work beautifully on your vehicle.  Please refer to the
	pictures below for installation instructions.
		1.		2.		3.
			Remove the screws in Figure A with a Phillips screwdriver.  Untwist the sockets, then gently slide out the tail light.		After the tail light is removed, remove the screw in Figure B.		Remove the screw in Figure C to remove the Upper Quarter panel.
		4.		5.		6.
	Twist & lock socket into place.		Gently slide out the stock Upper Quarter Panel.		Take the new IPCW LED Upper Quarter Panel Light out of the box.		Install the LED Upper Quarter Panel Light following Steps 2 to 4 in reverse order.
		7.		8.		9.
	Figure A: are Phillips screws to
	remove the tail light.
	Figure B: is the (bottom) Phillips
	screw underneath the tail light to
	remove the Upper Quarter Panel.
	Figure C: is the (top) Phillips screw to remove the Upper Quarter Panel.		There will be 3 wires hanging from the back: (1) Black, (1) Red & (1) Blue with wire clamps.		Locate the factory socket on the vehicle that has the black, yellow, & light blue wires together.		Take the (1) Black wire of the LED light and clamp it to the black wire of this factory socket.
10.		11.		12.		13.
	Next, take the (1) Red wire of the LED light and clamp it to the yellow wire of this socket.		Then, take the (1) Blue wire of the LED light and clamp it to the light blue wire of this socket.		Make sure all clamps are securely locked in.		Now, re-install the tail light as in Step 1.
			Done! Thank you for your
			purchase. We hope you enjoy
			your new IPCW LED products!
			(Shown with IPCW LED Tail Light
			P/N: LEDT-311CB)