INSTRUCTIONS | LEDT-344C, CB, CR, CS |
|
|||||||||||||||||||||||||||
00-05 MONTE CARLO | LED TAIL LIGHTS | ||||||||||||||||||||||||||||
(If your vehicle is 06-07, see reverse side for instructions.) | |||||||||||||||||||||||||||||
Your new IPCW L.E.D. TAIL LIGHTS are quality-made products that will work beautifully on your vehicle. Please refer to the | |||||||||||||||||||||||||||||
pictures below for installation. | |||||||||||||||||||||||||||||
|
|
|
|||||||||||||||||||||||||||
1. | 2. |
|
3. | 4. | |||||||||||||||||||||||||
Open trunk and simply remove butterfly nuts using your hand and remove stock tail light. | Unplug main wire harness from vehicle connector. | Twist & unlock all sockets from stock light. | Remove all 3 light bulbs from vehicle sockets. | ||||||||||||||||||||||||||
5. |
|
6. |
|
7. |
|
|
|||||||||||||||||||||||
Keep the wire harness for installation on the (IPCW) LED TAILLIGHTS. | Take (IPCW) Taillight out of box and remove protective film from lens. | You should have 2 male connectors from the back of IPCW taillight. | Plug in the top 2-wire male connector to vehicle 's socket harness. Make sure to match black wire to black wire. | ||||||||||||||||||||||||||
9. |
|
10. |
|
11. |
|
12. |
|
||||||||||||||||||||||
Plug in the bottom 3-wire male connector to vehicle 's socket harness. Make sure to match black wire to black wire. | The small (194) socket would require no bulb, no wire connection, just twist & lock to seal the light. | Before installing make sure everything is connected & tightly sealed. | Now simply reconnect wire harness to vehicle factory plug and reinstall IPCW taillights on vehicle. | ||||||||||||||||||||||||||
13. |
|
|
|||||||||||||||||||||||||||
DONE! THANK YOU for your purchase . We hope you enjoy your new IPCW TAILLIGHTS. | |||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||