READ ME FIRST! Installation Instructions
LED3-1009C / CS L.E.D. THIRD BRAKE LIGHT 
(If your vehicle is a Titan, see reverse side for instructions.) 05-UP FRONTIER
Your new Crystal Eyes L.E.D. 3rd Brake Light is a quality-made product that will work beautifully on
your vehicle.  Please refer to the diagrams below for installation.
1.
2. 3.
Unscrew the stock third brake light from ceiling inside the cab.  Remove the stock light from outside. Unplug all connectors and remove bulbs.  You MUST REMOVE them, or they will burn out your new LED light.
4.
5.
6.
There are three wires from the truck: black, green/yellow striped, and red/black striped. Use clips provided with your new Crystal Eyes light by clipping white wire to green/yellow striped wire. Clip orange wire to red/black striped wire.
7.
8. 9.
Clip black wire to black wire. Gently tuck all the wires and clips into third brake light opening. Screw the new light back from the ceiling inside the cab.
10.
Thank you for your support on IPCW products.
Now enjoy your new Crystal Eyes 3rd Brake Light.
READ ME FIRST! Installation Instructions
LED3-1009C / CS L.E.D. THIRD BRAKE LIGHT 
(If your vehicle is a Frontier, see reverse side for instructions.) 04-UP TITAN
Your new Crystal Eyes L.E.D. 3rd Brake Light is a quality-made product that will work beautifully on
your vehicle.  Please refer to the diagrams below for installation.
1. 2. 3.
Pry open the two plastic covers on the ceiling from inside the cab.  Take off but keep the plastic covers. There is a screw hole inside the opening.
4. 5. 6.
Unscrew both sides. Unplug the connector from stock light. Remove the stock light.
7.
8. 9.
Take out the new Crystal Eyes 3rd brake light and find a square connector. Plug in the Crystal Eyes square connector to stock connector. Screw in new light from ceiling inside the cab and put plastic covers back on.
10.
Thank you for your support on IPCW products.
Now enjoy your new Crystal Eyes 3rd Brake Light.